Tag

Introduction: The electronics of this project was made a long time ago, after I have built several motion controllers with Arduino and stepper motors with different results. Most of them were simple one potentiometer kind of controller to allow movement in both directions, but soon this became too simple and hard replicate. I found this little company which made some motion controllers and offered a Kit to make a sma

Introduction: The Pl2 or “PI L Squared” it´s a tiny synth developed by the Ploytec team at Berlin. I was fascinated by their tiny synth when it came out because it had quite a distinctive 8 bit retro sound and I always have been a fan of this nostalgic sound… For me the main interest in this device came from the fact that is tiny and can be powered from either MIDI or USB depending in their versions

MidiBud is a DIY MIDI controller with a 16×2 display, EEPROM, push-button encoder and 5 buttons. The design is based on the Mutable Instruments MIDIpal. This is a revision of the board made by the Midisizer guys, so you can order your own PCB + Atmega Pre-programmed, get the list of components and build your own!! What is MIDIPAL?: The MIDIpal is a smart little MIDI processor. Insert it between a MIDI keyboard (